PS-1 Irrigation Pressure Switch

Simple water pressure sensor

The PS-1 Irrigation Pressure Switch adds irrigation water on/off data into the soil moisture data set. On/off data is a critical parameter to add to your system when using soil moisture sensors to monitor irrigation because it enables you to know your irrigation times.

The PS-1 registers ON at 5 PSI (±1.0 PSI). Because the sensor must be plumbed into the irrigation line, your data logger should be located where this can be done conveniently and cleanly.


Set Point5 psi switch (± 1 psi)
Maximum Pressure250 psi
Burst Pressure750 psi
Connection1/8 NPT male brass
Enclosure RatingNEMA 4, 13
Diaphragm MaterialBuna-N
Electrical Connection5 m cable with 3.5 mm connector for use with METER ZL6, Em50/50G, EM60/60G series loggers
AccessoriesBUSHING, 1/8" NPT female x 1/4" NPT male, brass
Request a quote

California requires the following notice

⚠️ WARNING: This product may contain chemicals including ethylene glycol, lead, nickel, styrene and cadmium, which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

PS-1 Irrigation Pressure Switch