Water activity: a better way to monitor moisture in plastics

Water activity: a better way to monitor moisture in plastics

Most plastic resin looks dry, but looks can be deceiving. If plastic parts are injection-molded with resin that has too much moisture in it, problems can occur–problems like ugly-looking parts, or parts that are too brittle. Water activity is a more accurate way to monitor moisture in plastic resin, enabling manufacturers to avoid these problems. Why?

Water activity: a clear winner over moisture content

Usually, injection molders use loss-on-drying balances to check their products for moisture, but when a dry product is dried, the weight doesn’t change much. When we dried LEXAN™ resin for 4 hours at 100 ºC, here’s what happened:

Figure 1. Lexan resin dried for 4 hours at 100 ºC: weight only changed 7 mg or 0.1%


The sample weight changed by only 7 mg or 0.1%. Water activity (aw) is a different way of looking at sample moisture. It measures the relative humidity of a sample instead of how much water is in it. When we measured the water activity of the same lexan sample, we saw this:

Figure 2. The water activity changed by more than 60% in the lexan resin sample dried for 4 hours at 100 ºC


The difference between the two Lexan samples is clear–the water activity changed by more than 60%.

Using the power of water activity to save time and money

Apply the extra power of water activity to a plastic resin sample using a simple process. First, take a water activity reading on the resin before drying. Then dry per the manufacturer’s specifications, and take a reading on the resin after drying. This gives a “target” water activity. For the next batch, simply take water activity readings on the resin every half hour or so. Once the “target” is reached, stop drying and start injection molding. Save time and also energy cost by not over-drying the resin.

Water activity is easy

It’s easy to use a water activity meter to measure moisture. Simply put 2-4 grams of sample in a sample cup, and close the sample chamber to get a reading in about 5 minutes. Operating the instrument doesn’t require any special training, reagents, sample preparation, or weighing.

Master the basics

Get the essentials of water activity condensed in this 20 minute webinar. You’ll learn:

-What water activity is
-How it’s different from moisture content
-Why it controls microbial growth
-How understanding water activity can help you control moisture in your product.

Measure water activity in 5 minutes

Not a “quick mode” reading, but a direct measure of water activity to 0.003. No calibration, no approximation.